ODOT offers no support for the Autodesk Civil3D State Kit. A link to download the State Kit is provided on the ODOT CADD Services webpage. All CADD related documentation, training, supporting files, and customization provided by ODOT shall be MicroStation CE and ORD based only.Ī Civil3D State Kit for use with Autodesk software is available for ODOT projects. ODOT will provide no support, standards, documentation, or guidance of any kind with respect to design and delivery of This document is specific to ODOT’s use of MicroStation CE and ORD. It is the primary design consultant’s responsibility to ensure that all sub-consultants use the agreed upon design package. Once the decision has been made to use either MicroStation CE, OpenRoads Designer, or Autodesk, there shall be no deviation from the agreed upon design package, and the same one shall be used for all aspects of the project until the project’s completion. ODOT will accept electronic deliverables generated from Autodesk tools however, the CADD design software to be used on a project shall be mutually agreed upon by the District and primary design consultant and shall be explicitly stated in the project’s scope of services. ODOT operates internally using MicroStation CONNECT Edition (CE) and OpenRoads Designer CONNECT Edition (ORD) software only. The professional shall have final responsibility for the accuracy of all input and output of computer-based applications. It is intended to provide uniform procedures and standards for ODOT staff and organizations that perform CADD related services for ODOT. This manual is not a textbook and does not exempt the professional from performing responsible engineering and/or surveying. This manual supersedes all CADD standards previously published in the Bridge Design Manual, the Right-of-Way Manual, and the Location and Design Manual, Volume 3. Information about ODOT’s transition from MicroStation and GEOPAK SELECTseries 4 to MicroStation CE and ORD is available on the ODOT CADD Services webpage. Projects started after Apare not permitted to use the ODOTcadd standards. The new Standards replace the previous “ODOTcadd” standards for all projects developed using MicroStation CE and ORD.Īll new projects started after Apusing Bentley software must use MicroStation CE or ORD using the OHDOT Standards. The new Standards are compatible with MicroStation CE and ORD and are not backwards compatible with previous software versions. The April 2019 update to ODOT’s CADD Standards included new “OHDOT” Standards for use with MicroStation CE and ORD. The standards referenced in this manual have been developed and tested using the MicroStation CE and ORD software versions listed on the ODOT CADD Services webpage. ODOT has adopted MicroStation CONNECT Edition (CE) and OpenRoads Designer CONNECT Edition (ORD) as its standard drafting and design software packages, respectively. The requirements presented in this manual ensure that CADD files can be used by the entire project team (surveyors, planners, environmentalists, designers, reviewers, contractors, etc.) throughout all phases of project development. Septem| Agency 100 General 101 IntroductionĬomputer-Aided Drafting and Design (CADD) is the preferred method of preparing plans for the Ohio Department of Transportation (ODOT).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |